FAQ's
Q) I am concerned with transporting rods with the tips raised into the air because of low hanging trees and other objects that might hit them.
A) The angle of each rod holder can be adjusted to wherever the user would like using the pin/rail system. This allows the user to lower the rod tips to any angle they choose. Most public roads provide enough clearance for the transport of most fishing rods in the upright position, however please be aware of your rod tip height at all times.
Q) What is keeping the rods from falling out of the system?
A) The rods are very secure inside the rod holders and typically do not need any sort of extra security while under transport. If you are traveling with the rod holders below 45 degree angles, or if you would just like extra security, we recommend using the adjustable reel leash straps available from Beson Fishing. Each rod holder has two hooks built into the cylinder which can be used to strap and secure the reels to the system.
Q) What is preventing the system from sliding and moving in the bed of the truck?
A) Every Rod Wrangler comes with adjustable latching arms that connect to the anchor points in the bed of the truck. These are constructed of 1/8” thick stainless steel square tubing and are capable of supporting loads MUCH larger than fishing rods and reels.
Q) What materials are used to make the Rod Wrangler?
A) Each Rod Wrangler is constructed of marine grade materials and is made in the USA. The baseplate is constructed of marine board (UV resistant HDPE) and the rails, pivot arms, and rod holders are constructed of polypropylene which contains a UV additive for UV protection, and mineral fill to make it stronger and more rigid. All of the fasteners and pins are constructed of 316 stainless steel, so corrosion will never be an issue. The adjustable arms are constructed of 304 stainless steel with an anti-corrosive primer and powder coat, which also makes them extremely resistant to corrosion.
Q) I am concerned with dirt and debris getting into my reels while transporting.
A) Each rod holder has drainage holes in the bottom which allow the user to hose/ wash down all your rods and reels while inside the system. This should help get rid of any debris you picked up while fishing or transporting. We also recommend using a reel cover while under transport to assist with preventing dirt from entering the reel.
Q) I am concerned with theft in my area. Is there a way to lock my rods and reels into the system?
A) Unfortunately there is no way to secure the rods and reels to the Rod Wrangler at the moment, however Beson Fishing is currently designing a solution to prevent theft. Currently, only The Rod Wrangler baseplate can be secured to the truck bed using a cable lock through the handles of the baseplate.
Q) Will the Rod Wrangler fit in my vehicle?
A) Please refer to the product pages for the dimensions of each Rod Wrangler to check the fitment for your vehicle. There is also a list of specific truck model fitments on each page. For van and SUV fitments, please refer to the width of the specific Rod Wrangler model listed in the dimensions.